19 October 2009

PIC16F877A-I/P Microchip MCU

Features:
High-Performance RISC CPU:
• Only 35 single-word instructions to learn
• All single-cycle instructions except for program branches, which are two-cycle.
• Operating speed:
DC – 20 MHz clock input DC–200 ns instruction cycle
• Up to 8K x 14 words of Flash Program Memory, Up to 368 x 8 bytes of Data Memory (RAM), Up to 256 x 8 bytes of EEPROM Data Memory
• Pinout compatible to other 28-pin or 40/44-pin PIC16CXXX and PIC16FXXX microcontrollers

Peripheral Features:
• Timer0: 8-bit timer/counter with 8-bit prescaler
• Timer1: 16-bit timer/counter with prescaler, can be incremented during Sleep via external crystal/clock
• Timer2: 8-bit timer/counter with 8-bit period register, prescaler and postscaler
• Two Capture, Compare, PWM modules
- Capture is 16-bit, max. resolution is 12.5 ns
- Compare is 16-bit, max. resolution is 200 ns
- PWM max. resolution is 10-bit
• Synchronous Serial Port (SSP) with SPI™ (Master mode) and I2C™ (Master/Slave)
• Universal Synchronous Asynchronous Receiver Transmitter (USART/SCI) with 9-bit address detection
• Parallel Slave Port (PSP) – 8 bits wide with external RD, WR and CS controls (40/44-pin only)
• Brown-out detection circuitry for Brown-out Reset (BOR)

Analog Features:
• 10-bit, up to 8-channel Analog-to-Digital Converter (A/D)
• Brown-out Reset (BOR)
• Analog Comparator module with:
- Two analog comparators
- Programmable on-chip voltage reference (VREF) module
- Programmable input multiplexing from device inputs and internal voltage reference
- Comparator outputs are externally accessible

Special Microcontroller Features:
• 100,000 erase/write cycle Enhanced Flash program memory typical
• 1,000,000 erase/write cycle Data EEPROM memory typical
• Data EEPROM Retention > 40 years
• Self-reprogrammable under software control
• In-Circuit Serial Programming™ (ICSP™) via two pins
• Single-supply 5V In-Circuit Serial Programming
• Watchdog Timer (WDT) with its own on-chip RCoscillator for reliable operation
• Programmable code protection
• Power saving Sleep mode
• Selectable oscillator options
• In-Circuit Debug (ICD) via two pins

CMOS Technology:
• Low-power, high-speed Flash/EEPROM technology
• Fully static design
• Wide operating voltage range (2.0V to 5.5V)
• Commercial and Industrial temperature ranges
• Low-power consumption

11 October 2009

TMS4416-15NL 20-Pin DIP



Feature:
- Dynamic RAM
- 16,384 Word by 4 Bit
- TTL compatible 150ns
- 3-State Unlatched Outputs
- Single +5V Supply (10% tolerance)
- Low refresh periode 4ms
- Operating Power Dissipation 200mW
- Standby Power Dissipation 17.5mW

Programming Service YAESU VERTEX VXR-9000 Repeater



Programming services:
- Set the receive frequency / Rx repeater.
- Set the transmit frequency / Tx repeater.
- Set the type signaling system.
- Set the ID repeaters.
- Set the RF Power repeaters.
- Set the Time Out Timer / TOT repeater

Programming Service YAESU VERTEX VXR-7000 Repeater



Programming services:
- Set the receive frequency / Rx repeater.
- Set the transmit frequency / Tx repeater.
- Set the type signaling system.
- Set the ID repeaters.
- Set the RF Power repeaters.
- Set the Time Out Timer / TOT repeater

Programming Service TAIT TB8100 UHF Repeater



Programming services:
- Set the receive frequency / Rx repeater.
- Set the transmit frequency / Tx repeater.
- Set the type signaling system.
- Set the ID repeaters.
- Set the RF Power repeaters.
- Set the Time Out Timer / TOT repeater

Programming Service KENWOOD TKR-850 UHF Repeater



Programming services:
- Set the receive frequency / Rx repeater.
- Set the transmit frequency / Tx repeater.
- Set the type signaling system.
- Set the ID repeaters.
- Set the RF Power repeaters.
- Set the Time Out Timer / TOT repeater

Programming Service TAIT TB7100 VHF Repeater



Programming services:
- Set the receive frequency / Rx repeater.
- Set the transmit frequency / Tx repeater.
- Set the type signaling system.
- Set the ID repeaters.
- Set the RF Power repeaters.
- Set the Time Out Timer / TOT repeater

Programming Service KENWOOD TKR-750 VHF Repeater



Programming services:
- Set the receive frequency / Rx repeater.
- Set the transmit frequency / Tx repeater.
- Set the type signaling system.
- Set the ID repeaters.
- Set the RF Power repeaters.
- Set the Time Out Timer / TOT repeater

Programming Service KENWOOD TKR-820 UHF Repeater



Programming services:
- Set the receive frequency / Rx repeater.
- Set the transmit frequency / Tx repeater.
- Set the type signaling system.
- Set the ID repeaters.
- Set the RF Power repeaters.
- Set the Time Out Timer / TOT repeater

Programming Service KENWOOD TKR-720 VHF Repeater



Programming services:
- Set the receive frequency / Rx repeater.
- Set the transmit frequency / Tx repeater.
- Set the type signaling system.
- Set the ID repeaters.
- Set the RF Power repeaters.
- Set the Time Out Timer / TOT repeater

09 October 2009

PIC18F4585-I/P Microchip MCU

FEATURE:
------------
- Package PDIP40
- Packaging tube
- Lead Spacing 2.54mm
- Op.Temperature -40 ~ 85°C
- Series PIC18
- Architecture 8-bit
- Speed 40MHz/10MIPS
- Internal Oscillator 8MHz,32kHz
- Memory Type PIC18F4585
- Program Memory 24k x 16
- EEPROM 1024
- RAM 3328
- Self Program Yes
- I/O 36
- A/D 11x 10-bit
- Interfaces 0 -UART , 1 -A/E/USART , 0 -SPI , 0 -I2C , 1 -MSSP(SPI/I2C) , 0 -SSP(SPI/I2C)
- Timers 1x 8-bit ,3x 16-bit
- Op.Voltage 2V ~ 5.5V
- Stack 31-level
- Power-On Reset Yes
- Brown-Out Reset
- Watchdog Yes
- Max. Clamp Current ±20mA
- Max. Sink/Source ±25mA

PIC18F4580-I/P Microchip MCU

- Package PDIP40
- Lead Spacing 2.54mm
- Op.Temperature -40 ~ 85°C

FEATURE:
------------
- Architecture 8-bit
- Speed 40MHz/10MIPS
- Internal Oscillator 8MHz,32kHz
- Memory Type PIC18F4580
- Program Memory 16k x 16
- EEPROM 256
- RAM 1536
- Self Program Yes
- I/O 36
- A/D 11x 10-bit
- Interfaces 0 -UART , 1 -A/E/USART , 0 -SPI , 0 -I2C , 1 -MSSP(SPI/I2C) , 0 -SSP(SPI/I2C)
- Timers 1x 8-bit ,3x 16-bit
- Op.Voltage 2V ~ 5.5V
- Stack 31-level
- Power-On Reset Yes
- Brown-Out Reset
- Watchdog Yes
- Max. Clamp Current ±20mA
- Max. Sink/Source ±25mA

CNY17 CNY17-1 CNY17-2 CNY17-3 CNY17-4 CNY17F-1 CNY17F-2 CNY17F-3 CNY17F-4 Phototransistor Optocouplers

CNY17-1/2/3/4 and CNY17F-1/2/3/4 are also available in white package by specifying M suffix (eg. CNY17-F2M)

Features:
-----------
- UL recognized (File # E90700)
- VDE recognized:
- Add option V for white package (e.g., CNY17F-2VM)
- File #102497 Add option 300 for black package (e.g., CNY17F-2300)
- File #94766 Current transfer ratio in select groups.
- High BVceo-70V minimum (CNY17X/MCNY17FX/M, MOC8106/7/8)
- Closely matched current transfer ratio(CTR) minimizes unitto-unit variation.
- Very low coupled capacitance alongwith no chip to pin 6 base connection for minimum noise susceptability (CNY17FX/M, MOC810X).

Applications:
--------------
-Power supply regulators
-Digital logic inputs
-Microprocessor inputs
-Appliance sensor systems
-Industrial controls

Description:
-------------
The CNY17, CNY17F and MOC810X devices consist of a Gallium Arsenide IRED coupled with an NPN photo transistorin a dual in-line package.

Code "A08" RF Semiconductor


Features
• Lead-free Option Available
• Usable Gain to 5.5 GHz
• High Gain:
32.5 dB Typical at 0.1 GHz
22.5 dB Typical at 1.0 GHz
• Low Noise Figure:
3.3 dB Typical at 1.0 GHz
• Surface Mount Plastic Package
• Tape-and-Reel Packaging Option Available
• Lead-free Option Available



Code "A06" RF Semiconductor


Features
• Cascadable 50Ω Gain Block
• Low Operating Voltage: 3.5 V Typical Vd
• 3 dB Bandwidth: DC to 0.8 GHz
• High Gain: 18.5 dB Typical at 0.5 GHz
• Low Noise Figure: 3.0 dB Typical at 0.5 GHz
• Surface Mount Plastic Package
• Tape-and-Reel Packaging Available
• Lead-free Option Available


Code "A" RF Semiconductor



Features
• High Dynamic Range Cascadable 50Ω or 75Ω Gain Block
• 3 dB Bandwidth: 50 MHz to 1.3 GHz
• 17.5 dBm Typical P1 dB at 0.5 GHz
• 3.6 dB Typical Noise Figure at 0.5 GHz
• Surface Mount Plastic Package
• Tape-and-Reel Packaging Option Available
• Lead-free Option Available

PIC18F4455-I/P Microchip MCU

FEATURE:
-Packaging tube
-Lead Spacing 2.54mm
-Op.Temperature -40 ~ 85°C
-Series PIC18
-Architecture 8-bit
-Speed 48MHz/12MIPS
-Internal Oscillator 8MHz, 32kHz
-Memory Type PIC18F4455
-Program Memory 12k x 16
-EEPROM 256
-RAM 2048
-Self Program Yes
-I/O 35
-A/D 13x 10-bit
-Interfaces 0 -UART , 1 -A/E/USART , 0 -SPI , 0 -I2C , 1 -MSSP(SPI/I2C)
-Timers 1x 8-bit ,3x 16-bit , 0 - 32-bit
-Op.Voltage 2V ~ 5.5V
-Stack 31-level
-Power-On Reset Yes
-Brown-Out Reset
-Watchdog Yes
-Max. Clamp Current ±20mA
-Max. Sink/Source ±25mA

08 October 2009

USB Programming Cable for Motorola GP338 GP328

Brand new good quality programming cable for Motorola radios, including:
- GP338, GP328, GP240, GP280
- GP238, GP240, GP280,
- GP318, GP320, GP328, GP329, GP338, GP339, GP340, GP360, GP380,
- GP540, GP550, GP560, GP561, GP580,
- GP640, GP650, GP680,
- HT1250, HT1250LS, HT1550, HT1550LS, HT1550XLS, HT750,
- MTX8250, MTX8250LS, MTX850, MTX850LS,
- MTX900, MTX9250, MTX950, MTX960M,
- PRO5150, PRO5350, PRO5450, PRO5550, PRO5750,
- PRO7150, PRO7350, PRO7450, PRO7550, PRO7750, PRO9150,
- PTX700, PTX760, PTX780

USB driver supplied. Programming software not included.

Please note DOS does not support USB devices. You will need Windows based software to work with USB programming cable.